遥感技术在“6·17”丹巴堵江泥石流灾害链灾区应急救援抢险决策中的应用     

唐尧  王立娟  赵娟  张成信 《中国地质调查》2020,7(5):114-122

2020年6月17日,四川丹巴县半扇门镇梅龙沟发生泥石流,阻断小金川河,形成堰塞湖,造成重大财产损失与人员伤亡。为掌握第一手灾情,辅助开展应急救援,以国产高分二号卫星数据为主要数据源,结合无人机航空摄影数据和灾后现场调查等资料,开展了“6·17”丹巴堵江泥石流灾害链灾区应急调查与分析。研究认为: 灾区影响人口约6.5万人; 国网丹巴县供电公司应急救援队与小金县联通通信应急抢险救援队距离最近,半扇门中学等5所学校可作为临时安置避难场所备选; 受影响矿山企业6家、重要水库1座、水电站1座; 泥石流沟总体呈NW—SE向展布,掩没面积约14.27万m²; 堰塞湖湖面面积约1.03 km²,淹没区约49.8万m²,路基路面全毁路段约2.1 km,下游疑似灾害隐患点9处,因灾受损民居25处、桥梁5处; 优选了2条灾后通达性较好的通往泥石流重灾区的救援生命线。借助遥感技术深入分析泥石流灾害链影响人口等灾情先期研判、灾情灾损应急调查及应急救援生命通道优选,对我国西南山区类似条件地质灾害隐患点的应急抢险救援、防灾减灾工作具有重要的指导意义。  相似文献   

Crack nucleation in saturated porous media     

Luc Dormieux  Eric Lemarchand  Thomas Carlioz  Laurent Jeannin 《国际地质力学数值与分析法杂志》2020,44(5):553-574

Crack nucleation has been the subject of important contributions in the last two last decades. However, it seems that few attention has been granted to the case of saturated porous media. This is the question addressed in the present paper which is devoted to nucleation in traction mode. From a physical point of view, nucleation is a sudden phenomenon, so that the material response is both adiabatic and undrained. In the spirit of the variational approach, the nucleated crack is viewed as the final state of a region of space in which the material undergoes a full damage process. In traction mode, the opening of a saturated crack in undrained condition induces a drop of fluid pressure. In case of low fluid compressibility, the presence of the fluid delays the brittle failure usually associated with nucleation, as long as the fluid pressure remains above the saturation vapor pressure. Nucleation is therefore possible only if a partial vaporization of the fluid takes place.  相似文献   

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis     

Ramin Pakzad  Shanyong Wang  Scott W. Sloan 《国际地质力学数值与分析法杂志》2020,44(10):1472-1494

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.  相似文献   

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials          下载免费PDF全文

Chao Jiang  Gao‐Feng Zhao 《国际地质力学数值与分析法杂志》2018,42(4):674-693

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.  相似文献   

跨海大桥建设对胶州湾北部冬季结冰现象的影响     

石晓雨  张日东  张文静  张可玟 《海洋通报》2018,(6):633-642

本文利用台站观测、卫星遥感以及专项调查等多种数据,综合分析了近年来胶州湾典型水文气象要素的变化特征及建桥前后水动力环境等的变化对冬季冰情的影响。结果显示,建桥以来冰情较重的年份冬季气温和年最低气温均处于近30年的低位,重冰期与年最低气温时段相吻合,且以跨海大桥为界,北部海湾结冰现象严重,而南部几乎无结冰。基于区域海洋水动力模型(ECOM)的模拟结果显示,跨海大桥建设可以从几个方面影响胶州湾北部海冰的生消,即大桥建设使胶州湾尤其是大桥北侧的水动力环境弱化,落潮时桥北侧水体堆积,涨潮时桥北侧向陆一侧水位减小;大桥对桥位南北1.5 km周围涨、落潮流场产生影响;流场的变化又使得悬浮物对流扩散和沉积物输运发生改变,大桥北侧局部区域水深变浅。  相似文献   

Micromechanical approach to effective viscoelastic properties of micro‐fractured geomaterials          下载免费PDF全文

Cássio B. Aguiar  Samir Maghous 《国际地质力学数值与分析法杂志》2018,42(16):2018-2046

The aim of this paper is to formulate a micromechanics‐based approach to non‐aging viscoelastic behavior of materials with randomly distributed micro‐fractures. Unlike cracks, fractures are discontinuities that are able to transfer stresses and can therefore be regarded from a mechanical viewpoint as interfaces endowed with a specific behavior under normal and shear loading. Making use of the elastic‐viscoelastic correspondence principle together with a Mori‐Tanka homogenization scheme, the effective viscoelastic behavior is assessed from properties of the material constituents and damage parameters related to density and size of fractures. It is notably shown that the homogenized behavior thus formulated can be described in most cases by means of a generalized Maxwell rheological model. For practical implementation in structural analyses, an approximate model for the isotropic homogenized fractured medium is formulated within the class of Burger models. Although the approximation is basically developed for short‐term and long‐term behaviors, numerical applications indicate that the approximate Burger model accurately reproduce the homogenized viscoelastic behavior also in the transient conditions.  相似文献   

深水铺管船托管架疲劳分析及动态监测点选取研究     

闫宏生  王哲  王晓波  陈永訢  孟祥伟 《海洋工程》2018,36(1):107-113

作为S型铺管作业的关键性装备,托管架长期承受着交变载荷的作用,随着海洋开发向超深水发展,结构疲劳破坏问题不容忽视。采用疲劳谱分析的方法并结合线性累积损伤理论,对托管架结构频域下的变形进行了分析,计算了正常海况下和极端海况下托管架疲劳损伤度并对疲劳寿命进行了评估。研究发现托管架在正常海况下作业符合安全要求,在极端海况下局部结构会受到破坏。并从托管架结构安全监测角度,筛选了结构疲劳分析关键点位,为监测点位的选取提供了依据。  相似文献   

无人机在重大地质灾害应急调查中的应用   总被引：4，自引：0，他引：4  

郭晨  许强  董秀军  巨袁臻  宁浩 《测绘通报》2020,(10):6

传统的地质灾害应急调查受限于地形、天气等外界条件，不能快速全面地获取灾害的详细信息，而无人机具有灵活性强、时效性高和不受复杂地形影响等特点，在地质灾害应急调查中有独特的优势。本文以“6·24”新磨村滑坡和“10·11”白格滑坡为例，阐述了无人机数据获取及处理流程，重点介绍了无人机获取的数字地形产品在地质灾害精确描述、定性及定量分析中的应用。结果表明：无人机摄影测量技术为重大地质灾害应急调查提供了更加科学高效的现场影像采集和遥感成果处理及应用方案，为应急救灾工作的顺利实施及分析研判提供了重要数据支撑，科学有效地保证了现场施工救援人员的安全。  相似文献   

川藏铁路3000 m水平定向钻井技术方案          下载免费PDF全文

张恒春  刘广  吴纪修  王庆晓  于好善  刘志强  许洁 《探矿工程》2020,47(11):1-6

川藏铁路设计多条超长深埋隧道，且多处于高海拔、高陡斜坡及雪线以上的无人山区，地形险峻，起伏大，交通条件差。沿隧道轴线的水平定向钻井为隧道勘察提供了一种有效的勘察手段。结合工程及地层特点，从钻井设备、工艺等方面，为超长隧道勘察提供了一种3000 m级水平定向钻井技术方案。方案明确了井身结构、全面钻进和长钻程取心钻进工艺、钻井液措施及部分复杂情况应对措施。以较少的钻探工作量，为隧道勘察提供更加详细的实物地质资料，真实反映隧道内的地质情况。  相似文献   

溢油对海洋生态系统内在价值损害的评估——以“塔斯曼海”轮溢油事故为例     

严志宇  孙冰  付红蕊  任杰 《海洋科学》2020,44(4):85-89

作者籍以能值和生态炯分析,将海洋生态内在价值补充到溢油损害评估中,并以"塔斯曼海"轮溢油事故为例,分析了生态系统内在价值损害评估的特点。结果表明溢油生态内在价值损害大于对生态服务价值的损害,前者是后者的6.9倍;能值变化反映对资本积累的损害,生态炯更突出了溢油对初级生产力的生态系统的影响。本评价是现有溢油损害评价的补充,可为彻底、有效环境治理、生态修复提供保障,对海洋开发管理决策和公众环保意识的提高将有积极的影响。  相似文献